F1 : M_MENU F2 : A_MARK F3 : EDIT F4 : FILE
F5 : SETUP F6 : TEST F7 : LOAD F8 : COMM
FILE NAME [ ]
STATUS [ ]
[SEQUENCE FILE LOAD]
F4 : SEQUENCE FILE SAVE
FILENAME DATA TIME
>< NO FILE >
The function, the stored sequence file of the controller that you setting up on the F3 mode, loads
On the SD card. At load screen, if you press the direction key, be shown the Marking
Data list of sequence files. After find the file you want and press“ENTER”, it will start load.
If loading is finished normally, will be shown the message “LOAD DATA OK” on the status screen
<SEQUENCE FILE SAVE>
F1 : M_MENU F2 : A_MARK F3 : EDIT F4 : FILE
F5 : SETUP F6 : TEST F7 : LOAD F8 : COMM
FILE NAME [ ]
STATUS [ ]
[SEQUENCE FILE SAVE]
F4 : MARKING DATA LOAD
FILENAME DATA TIME
>< NO FILE >
The function that stored marking data in controller stores to the SD card.
Storing is the backup function of the data. When the data was disappeared by an error of the controller
and interruption of electric power, you can use that function.
Storing finish normally, will be shown the message “SAVE DATA OK” on the status screen
To Next Page
Loading...
Need help?
General