Press “Enter”, the screen is changed as below :
MULTIPLE (20) LINES BLOCK ? Select Multi Block (Refer to pg 13). (Default value is “N” )
-> In case you use multi block, please make it [Y] from [N[
OPTIMIZE 2D MATRIX MARKING ? : Select the type of 2D DATA MATRIX.
-> In case [Y], 2D DATA MATRIX is marked zig-zag.
In case [N], 2D DATA MATRIX is marked to one direction.
SOFTWARE HEAD PARKING ? :
Virtual origin function to determine whether to use. Default value is [N].
If this value is [Y], marking machine doesn`t return to home position.
Marking is finished after moving to the location which you assign on
.
SAVE MARK DATA TO LOG FILE ? : Deciding whether to use for saving the log data
to the USB and SD card as TXT file. ( Dafault value is [N] )
F1 : M_MENU F2 : A_MARK F3 : EDIT F4 : FILE
F5 : SETUP F6 : TEST F7 : LOAD F8 : COMM
X PARK POSITION [0000] 0.1mm./step
Y PARK POSITION [0000] 0.1mm./step
Reset Every [0000] Mark Cycles
Multiple (20) lines Block ? [ Y ]
Optimize 2DMatrix marking ? [ Y ]
Software Head Parking ? [ Y ]
Save mark data to log file ? [ Y ]
[ SETUP MODE]
CUSOR_MOVE : ENTER F5 : DATE CODE SET
Log Folder Name :
Log File Name :
To Next Page
Loading...