X PARK POSITION [0000] 0.1mm./step : X axis of Virtual origin which marking pin will come
after marking is finished in case using this function. ( Unit : 0.1 mm )
Y PARK POSITION [0000] 0.1mm./step : Y axis of Virtual origin which marking pin will come
after marking is finished in case using this function. ( Unit : 0.1 mm )
Ex> In case X PARK POSITION [0050]and Y PARK POSITION [0200]
RESET EVERY [0000] MARK CYCLES : Return to home position after specify the quantity.
And then stand by at specified location.
-> Marking location is changed during using virtual origin,
change the value of “ RESET EVERY [0000]”periodically to check the location of marking pin from
home position of marking head.
LOG FOLDER NAME : In case using this function, designate the folder name
which log file will be saved.
LOG FILE NAME : In case using this function, designate the name of log file.
To Next Page
Loading...