Recommended
uplink powers
Conditions
33% Works for most conditions.
100% ◦ Sensor is far from vessel (e.g. more than 800 m depending
on conditions, high depth)
◦ High level of interferences
◦ Issues receiving data
◦ Low SNR
4. In Refresh Rate, leave Fast selected.
Configuring Measurement Sending Sequence
You can configure the order and types of measurements (e.g. temperature, pitch, roll...)
sent to the receiver.
1. Press command + A or click Menu and click User Mode > Advanced
2. In Communications page, click in Data Sequence.
Catch Navigator | V1 | Sensor Configuration
21
To Next Page
Loading...
