Marport CATCH - Appendix; Frequency Plan

Appendix
Frequency Plan
It is important to carefully plan the setup of your sensors before adding them to the
system. You can create a table with a list of frequencies and complete it when you add
sensors.
Frequencies and intervals
The diagrams below show the bandwidth of the dierent types of Marport sensors and
intervals you must respect when adding other sensors.
Figure 1. PRP sensors (e.g. Catch sensor, Trawl Speed, Spread sensor...)
Example: If the frequency of the sensor is 40kHz, there should be no sensors between
39.9-40kHz and 40-40.1kHz.
Figure 2. Marport Pro sensors (e.g. Trident, Door
Explorer, Trawl Navigator, Speed Navigator)
Example: If the frequency of the sensor is 40kHz, there should be no sensors between
39.8-40kHz and 40-50.2kHz.
Catch Navigator | V1 | Appendix
60