Trawl Explorer | V2 | Installation
Installation
Learn how to install Trawl Explorer sensors on the trawl gear.
Installing a Trawl Explorer on the Trawl
We recommend to install the sensor on the headrope in order to see the trawl opening and fish
entering the trawl. You can also install it on the trawl tunnel to see fish going toward the codend.
Headrope
To install the sensor on the headrope, install it on a location corresponding to nodes 13, 12, 11 or 10
on the image below:
If you want to see the footrope, move back the sensor of a few meters, as illustrated below.
| 36
To Next Page