Trawl Explorer | V2 | Servicing and Maintenance
Cleaning the Sensor
You need to regularly clean the sensor for proper performance.
Wash the sensor with fresh water before you charge or store it.
Regularly check that the sensor is clean. If not:
• Remove any marine life with a piece of wood or screwdriver.
• Wash away mud or debris with warm water.
CAUTION: Do not use highly abrasive materials or jet wash.
CAUTION: Special care should be taken with sensors and components sensitive to
mechanical shock or contamination.
Maintenance Checklist
We recommend you to follow this maintenance schedule for better performance and to avoid any
trouble with the equipment.
Before use
• Check that all attachment equipment are not
worn or torn. Replace when appropriate.
• Check that the sensor is clean. See Cleaning
the Sensor on page 43 for cleaning
procedures.
After use Wash the sensor with fresh water.
Between uses
• When the sensor is not in use, store in a dry
area, without humidity, at a temperature
between -10° and 70 °C (14 to 158 °F).
• If you put the sensor into storage for a long
period of time, charge it once in a while. If
you do not, batteries can become inoperable.
Every 2 years Return the sensor to an approved Marport
dealer for inspection and maintenance.
| 43
To Next Page
Loading...