Chapter 4 INSTALLATION 29
4. INSTALLATION
4.1 I-Wave2
Handle
The I-Wave2
handle is provided pre-assembled, with the exception of the mechanical
plug head, whose mounting instructions are explained in Chapter 6.
In order to save and protect the batteries, the handle is placed in a special low-power
mode (Sleep mode) suitable for long storage and/or transportation.
With this mode activated, the I-Wave2
handle cannot be switched on nor by pressing
the buttons neither by moving it.
To disable the “Sleep mode” and re-activate the handle, it must be placed on a powered
stand charger. After that, the handle is active and it can work as described in Chapter
5.
WARNING:
Put the handle in the charger when not used.
Do not stick any kind of label on the plastic body in order to avoid
possible charging and transmission interferences.
The customization is allowed only on the removable metal plate (see
Figure 2-2 - ref. 4).
Direct Lock Star Lock
Figure 4-1.
I-Wave2
Handle.
To Next Page
Loading...
