76 / - Instruction Manual
7.1.1 Error list
In some cases the display might show an error symbol followed by the error code.
WARNING
If the battery of the handle is down, put it in the Stand charger for at
least one hour.
Errors
Error code Cause Remedy
E001 - E005 Contact Marposs.
E006 Zeroing is performed very
close to the limits of the
working range.
Perform again the zeroing
operation.
E007 - E034 Contact Marposs .
E035 - E040 Put the handle in the charger for a complete charging cycle.
E041 - E901 Contact Marposs.
E902 Turn off the handle, keep one of the two buttons pressed five
seconds over the Long press ( blue) then perform the
Reboot as described on paragraph 5.5. If the problem persists
contact Marposs.
E903 - E999 Contact Marposs.
To Next Page
Loading...
