20 / - Instruction Manual
2.2.5 Display Unit
The I-Wave2/Wave2 handle can work both connected with electronic units ( after
the required pairing), and in Stand-Alone mode, i.e. not connected to the electronic unit.
2.2.5.1 Marposs electronic units and software
The use of the I-Wave2 / Wave2 handle with Marposs electronics and software is
allowed only after the installation of 'Wave2 Driver'.
The following table shows the different compatibilities.
Table 2-2. Handle compatibility with Marposs electronics and software.
Elettronic/Software I-Wave2 Wave2
E9066
Merlin Family
Available soon
Nemo Available soon Available soon
Duo Not compatible Not compatible
QuickSPC Windows XP/VISTA/7/8/10 compatibility XP/VISTA/7/8/10 compatibility
QSPCW 3.7C up to
QSPCW v3.7G
Win7/8/10 compatibility from
QSPCW v.3.8
from QSPCW v3.8
+ Patch SM2P000057
Easy Acquisition 3.6.0 with Wave2 Driver v3.1.0 or
higher
with Wave2 Driver v3.4.0 or
higher
Drivers Library 3.2A with Wave2 Driver v3.1.0 or
higher
with Wave2 Driver v3.4.0 or
higher
EasyWedge v3.0 with Wave2 Driver v3.1.0 or
higher
-
Merlin Plus software
Available soon
R2G
Available soon
Please refer to “Wave2
Driver” manual for more details for the use with Quick SPC
TM
,
Easy Wedge, Easy Acquisition and Drivers library Marposs software.
For the use with Merlin, Merlin Plus and Merlin Plus Box
TM
software no driver installation
is required.
For more details, please refer to the User Manual of Electronic unit.
For the use with Merlin Plus Software and R2G application, refer to the Software
Manual.
2.2.5.2 R2G applications
The R2G application allows to program the I-Wave2
operating parameters in
absence of the electronic unit.
For more details, please refer to I-Wave2
Ready2Gauge manual (downloadable
from www.marposs.com in the dedicated I-Wave2 section).
To Next Page
Loading...
