Chapter 1 GENERAL INFORMATION 9
1.2 General safety information
WARNING
The safety of the apparatus is the responsibility of the installer
Failure to observe the following points may expose the user to serious
health and safety risks.
When using I-Wave2/Wave2 pay attention to the following indications that have been
designed to help the user to conserve their rights for the duration of the warranty period.
I-Wave2/Wave2
should only be used in environments suitable for heavy
industrial environments.
Before initializing and using the device, make sure that a plug head is
connected securely to the I-Wave2/Wave2
handle. Without a plug head
connected to the handle, Marposs cannot guarantee that the set up and
measurement operations will be executed correctly.
The battery pack contains a power management circuit and an incorrect removal
may damage the product and invalidate the warranty. The batteries pack
should only be removed by trained personnel from a Marposs Service Centre.
Please contact your local Marposs Service Centre to arrange for service.
Do not attempt to open the I-Wave2/Wave2
device in any way.
Do not use corrosive chemical products, solvents or aggressive detergents to
clean the I-Wave2/Wave2
device. Use a dry cloth to clean the external surfaces
of the device.
Use the battery charger in indoor.
These suggestions are valid for I-Wave2/Wave2 device and all its accessories
To Next Page
Loading...
