32 / - Instruction Manual
4.2 Wave2
Handle
The Wave2 handle comes pre-assembled, except for the electronic plug head, for
which assembly instructions are in Chapter 6.
To save and protect the batteries, the handle is placed in a special low-power mode
(Sleep mode), suitable for extended storage and transport.
With this mode activated, the Wave2 handle can not be switched on, neither by
pressing the button nor by moving it.
To deactivate “sleep mode” and reactivate the handle, place it in a powered stand
charger. After that, the handle is active and can operate as described in Chapter 5.
WARNING
:
In case of inactivity, place the handle in the charger.
Do not apply labels of any kind on the plastic body to avoid possible
interference to charging and transmission.
It is allowed to customize only the removable metal plate (see Ref. 4 in
Figure 2-2).
Figure 4-6.
Wave2 Handle
.
To Next Page
Loading...
