Martin MAC III User Manual

RDM 27
MAC III Wash supported standard commands
GET
allowed
SET
allowed RDM parameter ID’s (slot 21-22) Notes
Category – Network Management
DISC_UNIQUE_BRANCH
DISC_MUTE
DISC_UN_MUTE
Category - Status Collection
 QUEUED_MESSAGE
 STATUS_MESSAGES
 STATUS_ID_DESCRIPTION
 CLEAR_STATUS_ID
Category - RDM Information
 SUPPORTED_PARAMETERS
 PARAMETER_DESCRIPTION
Category – Product Information
 DEVICE_INFO
 DEVICE_MODEL_DESCRIPTION
 MANUFACTURER_LABEL
DEVICE_LABEL
FACTORY_DEFAULTS
 SOFTWARE_VERSION_LABEL
Category - DMX512 Setup
DMX_PERSONALITY
 DMX_PERSONALITY_DESCRIPTION
DMX_START_ADDRESS
 SLOT_DESCRIPTION
Category – Sensors See “RDM accessible onboard sensors” on page 28
 SENSOR_DEFINITION
SENSOR_VALUE
Category – Dimmer Settings Reserved for future use
Category – Power/Lamp Settings
DEVICE_HOURS
LAMP_HOURS
LAMP_STRIKES
LAMP_STATE
LAMP_ON_MODE
DEVICE_POWER_CYCLES
Category - Display Settings
DISPLAY_INVERT
DISPLAY_LEVEL
Category – Configuration
PAN_INVERT
TILT_INVERT
PAN _T ILT _SWAP
Category – Control
IDENTIFY_DEVICE
 RESET_DEVICE
PERFORM_SELFTEST
SELF_TEST_DESCRIPTION

Martin MAC III Specifications

General

Brand	Martin
Model	MAC III
Category	Light Fixture
Language	English