44 MAC III Wash user manual
Control panel menus
Firmware version 1.1.0
Commands marked * are not available when fixture is running on battery power.
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
SETUP WIZARD
Gives quick access to most frequently-used menus: FACTORY SETTINGS, DMX ADDRESS, PROTOCOL
SET, FIXTURE ID plus most frequently-used PERSONALITY settings: PAN/TILT SETTINGS, SPEED
SETTINGS, FANS, DIMMING CURVE, AUTOMATIC LAMP ON, DISPLAY. See table below for details of
these settings.
DMX ADDRESS 1 – 492
DMX address (new fixtures are supplied
with address set to 1)
FIXTURE ID 0000 – 9999 User-settable fixture ID number
PERSONALITY
PAN/TILT
SETTINGS
SWAP
Map DMX pan control to tilt channel and
vice versa
PAN INVERT Reverse DMX pan control: right → left
TILT INVERT Reverse DMX tilt control: down → up
MOVE ON RESET
Enable/disable pan/tilt movement when
fixture resets. Default = On
PAN & TILT
LIMIT SETTINGS
P/T LIMITATION Enable pan and tilt range limits
PAN MINIMUM Set minimum pan angle (0° – 360°)
PAN MAXIMUM Set maximum pan angle (360° – 0°)
TILT MINIMUM Set minimum tilt angle (-134° – 134°)
TILT MAXIMUM Set maximum tilt angle (134° – -134°)
P/T LIMIT AREA
Set pan/tilt to stay inside safe zone or stay
outside no-go zone (Inside/Outside)
DEFAULT LIMIT
SETTINGS?
Reset all pan and tilt limit settings to
factory defaults.
SPEED
SETTINGS
PAN & TILT
SPEED
Normal Normal speed pan and tilt
Fast Optimize pan/tilt movement for speed
Slow
Optimize pan/tilt movement for
smoothness
EFFECT SPEED
Follow P/T speed
Effects speed follows the speed setting
applied to pan and tilt via DMX or in
control menu
Normal Normal effects speed
Fast Optimize effects movement for speed
Slow
Optimize effects movement for
smoothness
Table 3: Control menus
To Next Page
Loading...
Need help?
General
