26 MAC III Wash user manual
RDM
The MAC III Wash can communicate using RDM (Remote Device Management) in accordance with ESTA’s
American National Standard E1.20.
RDM is a bi-directional communications protocol for use in DMX512 control systems, it is the open standard
for DMX512 device configuration and status monitoring.
The RDM protocol allows data packets to be inserted into a DMX512 data stream without adversely
affecting existing non-RDM equipment. The RDM protocol allows a console or dedicated RDM controller to
send commands to and receive messages from specific fixtures.
RDM ID
Each MAC III Wash has an RDM UID that makes it uniquely addressable. This can be found in the control
panel menus under FIXTURE INFORMATION. RDM UID shows the fixture’s factory-set unique ID for
identification in RDM systems.
RDM communication
The MAC III Wash will respond to:
1. ”MAC III Wash supported standard commands” (see page 27).
2. ”MAC III Wash supported manufacturer specific commands” (see page 28).
To Next Page
Loading...
Need help?
General
