Service and display messages 49
Service and display messages
The MAC III Wash gives service and maintenance information by displaying a large 3- or 4-character short
code and a smaller full-text message in the display. The short code is visible at a distance, allowing easier
reading with the fixture still in the rig, for example, while the full-text message gives more detailed
information.
Warning messages
Warning messages indicate that either:
• problems might appear in the future if no action is taken, or
• the user needs to pay special attention to a function or procedure when working with the fixture.
The MAC III Wash communicates warnings as follows:
• Warning codes are shown continuously in the display and disappear when the user reacts to the warning.
• If more than one warning is detected, all warnings are displayed in sequence.
• If the display is inactive, the status LED in the center of the jog wheel flashes orange to indicate that there
is a warning. Activating the display will show the warning.
The MAC III Wash can display the warning messages listed in Table 4 on page 50.
Error messages
Error messages indicate that there is a serious problem. The MAC III Wash communicates errors as follows:
• Error messages flash in the display.
• If more than one error is detected, the fixture flashes all errors three times each.
• Errors are shown in the display regardless of display status: they override an inactive display and any
other information that the display might be showing.
• If an error is present, the status LED in the center of the jog wheel flashes red.
The MAC III Wash can display the error messages listed in Table 5 on page 51.
To Next Page
Loading...
Need help?
General
