Martin MAC III - Service Utilities and Calibration

48 MAC III Wash user manual
SERVICE
PAN/TILT
FEEDBACK*
On
Enable pan/tilt position feedback
systems
Off Disable pan/tilt position feedback
ADJUST*
PAN/TILT
SENSOR
CALIBRATION
PAN/TILT AT
END STOP
Move pan and tilt to end stops following
instructions in the display, then execute to
calibrate pan and tilt sensors
CMY MODULE DIMMER
For use by qualified service technicians –
see Martin service documentation before
entering this menu
EFFECT MODULE SHUTTER
PAN/TILT
MODULE
PAN
TILT
CALIBRATION*
DIMMER ... TILT
Set individual effects to calibration
positions (approx. +/- 5% offset available)
LOAD DEFAULTS? Load factory default calibration settings
SAVE FACTORY DEFAULT?
Replace factory default calibration settings
with current calibration settings
UPDATE
FIRMWARE
UPDATE
Update fixture firmware from bank shown
in display
BANK Firmware bank version
LOCATION Location of firmware bank
EVENT LOG
EVENT LOG TRIGGER Triggers generation of event log
CLEAN EVENT LOG Clears event log and any current errors
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
Table 3: Control menus