Clock Mode
Pushing the button switches the
display between the clock mode “CLOCK”
and the hour meter mode “HOUR” in the
following order:
CLOCK→HOUR→CLOCK
To Set the Clock
1. Set into the clock mode.
2. Press the watch button for 3-5 seconds.
3. Press the “KM/MILE” button to set the
hours.
4. Press the “TRIP/ODO” button to set the
minutes.
5. Press the watch button for 3-5 seconds,
and then release it, the clock will begin
to work.
Fault Codes Display Of Electronic
Injection System
When the faults come out , meter will display
the fault codes to guide the repair.
See attachment for faults code（page 11-1）
When the fault code is confirmed and has
been repaired, you just need to press the
button, meter will go back to clock
mode.
To Next Page
Loading...
