7-14
install new plugs.
6. Attempt to start the engine. If necessary,
repeat the drying procedure.
7. Take the vehicle to your dealer for
service as soon as possible, whether you
succeed in starting it or not.
8. If water has been ingested into the CVT,
make sure inspect the hole without water
left inside. If it is muddy water, open the
CVT cap and wash the parts before
reassemble.
9. check the gearshift, release the water
inside. Wash it if it is necessary.
CAUTION：
：：
：
Make sure all motion parts coated with
grease after wash and reassemble.
1．Air filter case check hose
1. Drive select lever box check hose
To Next Page
Loading...
