4 5
model no. 055-6751-6 | contact us 1-800-689-9928
SPECIFICATIONS
SAFETY GUIDELINES
SPECIFICATIONS SAFETY GUIDELINES
• Keep guards in place and in working order.
• Remove adjusting keys and wrenches. Form habit of checking to see that keys and adjusting
wrenches are removed from tool before turning it on.
• Keep work area clean. Cluttered areas and benches invite injuries.
• Don’t use in dangerous environment. Don’t use power tools in damp or wet locations, or expose
them to rain or snow. Keep work area well lighted.
• Keep children away. All visitors should be kept at a safe distance from work area.
• Make workshop childproof with padlocks, master switches, or by removing starter keys.
• Don’t force the tool. It will do the job better and safer at the rate for which it was designed.
• Use the right tool. Don’t force tool or attachment to do a job for which it was not designed.
• Wear proper apparel. Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewellery
which may get caught in moving parts. Non-slip footwear is recommended. Wear protective hair
covering to contain long hair.
• Always use safety glasses. Also use face or dust mask if cutting operation is dusty. Everyday
eyeglasses only have impact-resistant lenses, they are not safety glasses.
• Secure work. Use clamps or vise to hold work when practical. It’s safer than using your hand and it
frees both hands to operate tool.
• Don’t overeach. Keep proper footing and balance at all times.
• Maintain tools with care. Keep tools sharp and clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
• Disconnect tools before servicing; when changing accessories, such as blades, clamps, extensions,
and the like.
• Reduce the risk of unintentional starting. Make sure the switch is in the OFF position before
plugging in.
• Use recommended accessories. Consult the owner’s manual for recommended accessories. The
use of improper accessories may cause risk of injury to persons.
Motor 120V AC, 60 Hz, 15A
Speed 5000 RPM (no load)
Blade 10” (25.4 cm) 40-tooth carbide-tipped
Laser Class IIIa
Laser wavelength 630-665 nm
Laser output <5 mW
Cutting Capacity
3 1/2 x 12” (8.9 x 30.5 cm) crosscut at 0° mitre, 0° bevel
3 1/2 x 8 1/2” (8.9 x 21.6 cm) mitre cut at 45° mitre, 0° bevel
1 1/2 x 8 1/2” (3.8 x 21.6 cm) compound cut at 45° mitre, 45° bevel
1 1/2 x 12” (3.8 x 30.5 cm) crosscut at 45° bevel, left
Weight 32 lb (14.5 kg)
WARNING!
To reduce the risk of injury, read the instruction manual.
WARNING!
Read and understand all instructions. Failure to follow the warnings and instructions listed below
may result in electrical shock, fire and/or serious injury.
To Next Page
Loading...
Need help?
General
