MasterCraft 055-6751-6 User Manual

14 15
model no. 055-6751-6 | contact us 1-800-689-9928
2
1
KEY PARTS DIAGRAM ASSEMBLY AND ADJUSTMENTS
REMOVING AND INSTALLING THE BLADE
Removing blade
(Fig. 1 to 4)
•
Unplug the tool from the power source.
• Adjust the lock-down pin to raise the cutting head.
• Loosen the cover plate screw (1) about 4 turns with a
star-head screwdriver. Do not remove this screw from
the tool.
• Lift and hold up the lower blade guard (2) to expose
the threaded blade bolt (3).
• Press and hold the spindle-lock button (4) and rotate
the blade at the same time, until it is locked in
position.
• Continue to hold the spindle lock button to keep it
engaged, while using the wrench to turn the threaded
blade bolt clockwise and remove the threaded blade
bolt.
• Remove the outer flange (5) and the blade (6). Wipe
the flanges and spindle to remove any dust and debris.
Installing blade (Fig. 1 to 4)
Unplug the mitre saw before changing/installing the blade.
•
Install a 10” (25.4 cm) blade with 5/8” (15.9 mm) arbor
onto the arbor shaft (7). Match the arrow on the blade
with the arrow on the upper blade guard. Make sure
that the blade teeth are pointing downward.
No. Description
15 Dust bag
16 Blade
17 Motor
18 Spindle lock
19 Lock-down pin
20 Slide carriage lock knob
No. Description
21 Bevel lock knob
22 Bevel scale
23 Table
24 Mitre scale
25 Hex wrench
WARNING!
Always be sure that the tool is switched off and unplugged before adjusting or checking function
on the tool. Failure to switch off and unplug the tool may result in serious personal injury from
accidental start-up.
WARNING!
Only use a 10” (25.4 cm) diameter blade. To avoid injury from an accidental start, make sure the
switch is in the OFF position and the plug is not connected to the power source outlet.
NOTE:
Pay attention to the pieces being removed, noting their position and the direction they face. Wipe the blade
collar clean of any sawdust before installing a new blade.
WARNING!
Your saw should NEVER be connected to the power source when you are assembling
parts, making adjustments, installing or removing blades, cleaning, or when it it not in use.
Disconnecting the saw will prevent accidental starting, which could cause serious personal injury.
WARNING!
Do not allow familiarity with the mitre saw to cause a lack of alertness. A fraction of a second of
carelessness is enough to cause severe injury.
3
15
20
22
21
2324
16
17 19
18
25

MasterCraft 055-6751-6 Specifications

General

Brand	MasterCraft
Model	055-6751-6
Category	Saw
Language	English