Mastervolt Mass Combi 12/1200-60

OPERATION
4.3.4 Under and over voltage (see figure 14) will flash You can restart the Mass Combi
only by switching the unit manually off and on with the
main switch on the Mass Combi after the overload is
removed or failure is solved.
The AC-input of the Mass Combi is, within limits, protected
against over and under voltage. See specifications in
section 9.2. The Mass Combi will switch to inverter mode if
the AC-input voltage is out of operating range and will
switch back if the AC-input voltage is present again. 4.3.3 Overheating
In the event of overheating the Mass Combi shuts down
(see chapter 8.1 for illumination of indicator lights). The
Mass Combi is automatically powered up again when the
temperature drops below the factory default threshold.
The DC-input of the Mass Combi is also, within limits,
protected against over and under voltage. See
specifications in section 9.1. The Mass Combi switches off
if the DC-input voltage is out of range.
Overheating is most likely caused by:
4.4 MAINTENANCE
x heavy or non-resistive loads operating for a longer time
x high ambient temperature
No specific maintenance is required. If necessary, use a
soft clean cloth to clean the Mass Combi. Never use any
liquids, acids and/or scourers.
x disrupted air flow (dust or too less space)
4.5 PROBLEM SOLVING
Refer to chapter 8 if a problem occurs.
18 EN / Mass Combi 12/1200-60 & 24/1200-35 / EN