Matica MC-L2 - Film Specifications; Lamination Film Types and Specifications

ⓒ2021 Matica Technologies Group. All rights reserved
36
4. Press ‘OK’ to set the temperature and go back to the previous step.
5. Press ‘MENU’ to go into the standby mode.
6. If any changes have been made, you will be prompted to save the changes.
Press ‘OK’ to save the new settings or ‘MENU’ if you do not want to save them.
3. Use the menu navigation
button to adjust the temperature for the
lamination heater.
It can be set between 120°C and 185°C (248°F and 365°F)
+/- increments of 5°C (9°F)
UP 500 / LO 500
W30 / READY
2019.07.29(V0XX)