MC310 USER GUIDE
For Europe
Warning
“This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.”
Product contains RF section (or module), compiled with ETSI EN 300 330 V2.1.1 (2017-02)
For US
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution!!!
• Any changes or modification not expressly approved by the party responsible for compliance could
void the user’s authorities to operate this equipment.
This equipment has been tested and found to comply with the limits for class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
For Canada
In English:
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following
two conditions:
(1)
This device may not cause interference; and
(2)
This device must accept any interference, including interference that may cause undesired operation of
the device.
In French :
Cet appareil est conforme aux RSS sans licence d’Industrie Canada. Son fonctionnement est soumis aux
deux conditions suivantes:
1) Cet appareil ne doit pas provoquer d'interférences; et
2) Cet appareil doit accepter toutes les interférences, y compris celles qui pourraient entraîner un mauvais
fonctionnement de l'appareil.
General Note: - This equipment must be used by – Ordinary person / Instructed person / Skilled person
To Next Page
Loading...
