16 Matrix ETERNITY NE Quick Start
Connecting SETU VP248 as Extended SIP Extension
You are recommended to complete the following steps before connecting the
Extended IP Phone to ETERNITY NE:
• Decide the location of the Extended IP Phone: within the same network or
outside, according to your installation scenario.
• Log in to the web-browser Jeeves. Read the topics “How to access Jeeves” and
“Basic Configuration” for instructions.
•Configure DHCP Server on the Network Parameters page under Basic
Settings of Jeeves.
• Assign an extension number to the Extended IP phone on the Extension
Numbering Plan page under Basic Settings of Jeeves.
• For the SIP extension number you assigned to the Extended IP phone,
configure these parameters on the MATRIX Extended IP Phone Settings page
of Jeeves.
• Enable Matrix Extended IP Phone Mode.
• Enter the MAC Address of the Extended IP Phone.
• Assign the Registrar Server IP Address, as per you installation scenario.
• For instructions, see the topic SIP Extensions in the System Manual.
Now, follow the steps described below to install the Extended IP phone. The
instructions are common for all models of the SETU VP248. For the purpose of
illustration, the premium model, SETU VP248P, has been used.
• Unpack the SETU VP248 box and verify package contents.
• Mount the phone on a desk or wall at a location convenient to you.
• Connect the Handset to the Phone body; plug the long straightened end of the
phone cord into the handset jack at the bottom of the phone, and the short end
in to the bottom of the handset.
To Next Page
Loading...
