PIPETTOR OVERVIEW
15
B.5 Hazards and Precautions
There are no known hazards associated with the IMPACT when it
is operated in accordance with the instructions in this manual.
However, you should be aware of situations that can result in
serious injury.
Note: Do not perform troubleshooting procedures on the internal
components unless instructed by Matrix Technologies service
personnel.
WARNING! Ensure that the power transformer is connected to a
power receptacle that provides voltage and current specified by
Matrix Technologies. Use of an incompatible power receptacle can
cause shock and fire hazard.
CAUTION! Use only the power transformer supplied by Matrix
Technologies. Use of an incompatible power transformer can
damage the pipettor.
CAUTION! Always turn off the power and unplug the power
transformer before cleaning the exterior. Fluid seepage can
damage internal components.
CAUTION! Do not immerse the unit in liquid. Fluid seepage can
damage internal components.
CAUTION! Do not autoclave the entire unit. Extreme heat can
damage the display and other electronic components.
Note: For autoclaving specific portions of the pipettor, refer to the
Autoclaving Procedures, or call Matrix Technologies, Technical
Service Department, for instructions.
CAUTION! Do not clean the keypad with bleach solution or other
solvents. Caustic cleaning solutions can damage the keypad.
CAUTION! Avoid excessive charging of the batteries when the
pipettor is not in use. Excessive charge to the batteries will
shorten the battery life and may damage the batteries.
To Next Page
Loading...