Matrix Impact2 - Programming the IMPACT 2; Program Selection; Program Recall

To Next Page

To Previous Page

PROGRAMMING AND OPERATION

C.2 Programming the IMPACT

C.2.1 Program Selection

To create and store programs in the IMPACT

1. Select the program number by pressing the [Prog] key,

then press the [Vol] key until the desired program number

is displayed.

2. Press and hold the [Prog] key, while simultaneously

pressing the Special Function key to enter the program-

ming mode. The prompt “Prog” will appear on the display.

3. Begin entering your new program (see Section C.1,

Programming the IMPACT, for programming instructions).

NOTE: When programming mode is active, the Speed

setting and Beep Tone symbols will blink.

After you have pressed the [Enter] key to save and exit the

program, your new program will be stored under the

selected program number. The program number will be

displayed for two seconds. (The first step of the newly

written program is displayed).

This program is ready to be run.

C.2.2 Program Recall

To recall a stored program:

1. Press the [Prog] key, then the [Vol] key to select the

desired program number.

2. Press the [Enter] key to activate the displayed program.