PROGRAMMING AND OPERATION
21
C.3 Reviewing the Program
After you have programmed your pipettor, you may want to review
the programming steps:
1. Set pipettor for RUN mode. Ensure that the pipettor is in
the RUN mode ("Run" appears in the lower left corner of the
display). If the display is flashing all pipetting operations, you
are still in the programming mode; press [Enter] to save the
program and exit.
2. Begin program. Run the program without using pipet tips or
aspirating fluid. Press the trigger for each step in the program.
3. Observe display. At each step of the program, observe the
display. If necessary, re-enter the programming sequence.
Listed below are a few helpful hints for reviewing your program:
n If your program is complex and contains several steps,
you may want to write the steps on paper before entering
the program steps (or use a copy of the programming
worksheet at the end of this manual). Check off each step
as you review the program.
n If your program is intended for paced dispensing, review
the program again, with the trigger depressed until the last
step. Check the dispense pace to ensure that you can
keep up with the dispense steps.
To Next Page
Loading...