11
i-32V5 MIDI Chillers and Inverter Air/Water heat pumps with axial fan
Do not perforate or burn
TRANSPORT AND STORAGE LIMIT TEMPERATURE
Minimum storage temperature [°C] -10°C
Maximum storage temperature [°C] +50°C
LIFTING AND HANDLING
The handling must be performed by qualied personnel, properly equipped with appropriate tools to the weight and the encumbrance of the
unit, in compliance with safety regulaons of accident prevenng.
It is recommended:
1. check the weight on unit technical label or on table of tecnical data
2. check moving the unit there are no disconnected paths, ramps, steps, doors that could aect the movement and damage the unit;
3. make sure the unit stands while moving;
4. prima di movimentare l’unità vericare che le arezzature siano idonee a sollevare e a preservare l’integrità dell’unità;
5. check the unit center of gravity and align it with liing point;
6. perform liing only by one of the listed procedures;
7. Before starng handling make sure the unit is in stable equilibrium
Following liing moes are allowed:
• - forkli truck
• - ropes/chains + sling bar
Make sure to tension the liing ropes gradually and check their correct posioning.
To Next Page
Loading...
