MAXA i-32V5C MIDI 0121 - Register Details: Settings, Temperatures, Alarms

i-32V5 MIDI Chillers and Inverter Air/Water heat pumps with axial fan
30

-





-




11. RESIDUAL RISK
The residual risks related to handling, installaon and normal operaon of the unit are shown below. Any failure by the user and installer to com-
ply with the instrucons / indicaons given in the manual (for which the references are given in the table) entails the persistence of these risks,
which cannot be eliminated by the manufacturer, who has already adopted all the necessary design measures because each risk is minimized.
Danger  Residual risk

Operator User
Transport phase




Mechanical: crushing caused by
the possible instability of the unit
during handling
The procedures for correct unit
handling and installaon are
indicated on the user-installer
manual under chapter 5, with in-
dicaon of the center of gravity,
of the liing points and equip-
ment. Protecon devices use is
also recommended as required
by current regulaons.
Failure by the installer to comply
with the installaon procedures.
X X
Mechanical: crushing caused by
the possible instability of the unit.
The procedures for proper unit
installaon are indicated on
user-installer manual under
chapter 5.
Failure by the installer to comply
with the installaon procedures.
X X
Mechanical: Cung / seconing
/ shearing caused by the fan not
protected against accidental
contacts
The user-installer manual under
chapter 9 contains specic warn-
ings, also relang to the roune
maintenance phases.
Removal of the protecon grid
by the user or maintenance
technician.
X X
Entanglement caused by the fan
not protected against accidental
contacts
The user-installer manual under
chapter 9 contains specic warn-
ings, also relang to the roune
maintenance phases.
Removal of the protecon grid
by the user or maintenance
technician.
X X
Mechanical: cung / abrasion
due to contact with the heat
exchange coil
The user-installer manual under
chapter 9 contains specic
warnings to be taken into consid-
eraon when working near the
baery.
Failure to observe the warnings
in the manual and on the label.
X X
Mechanical: slipping / falling
caused by ice / water near the
unit as a result of water leaks
In the user-installer manual
under paragraph 5.8 is recom-
mended to pay aenon to the
conveyance of the safety valve
and in paragraph 5.4 there are
indicaons regarding the surface
on which the unit rests. During
maintenance, the use of PPE and
the possible removal of all water
residues near the machine aer
intervenon is recommended..
Failure to comply with the in-
strucons given in the manual.
X X