MAXDATA PLATINUM - Intel Server Management; Security; Intrusion Switch Monitoring; Software Locks

15
MAXDATA PLATINUM Server Board
Intel
®
Server Management
Intel
®
Server Management
(ISM) is a system management package that is included on the
ISM CD. ISM applications interact with the integrated hardware system management features
of the server to allow you to monitor and manage a server from a remote workstation:
•
Remote connection from a Windows
®
-based client workstation over a LAN
, or over a
modem or direct serial connection to the emergency management port on the server.
•
Real-time monitoring and alerting for server hardware sensors.
•
Emergency management when the server is off (but still connected to AC power) lets
you verify the state of the server, diagnose hardware problems, and power on/off or
reset the server.
•
Ability to Run the Client System Setup Utility to change the configuration of the managed
server.
ISM
can use an optional service partition on the server that you are managing. The service
partition is a special disk partition on the system drive that contains a ROM-DOS operating
system and DOS-based utilities, including the System Setup Utility, FRU/SDR Load Utility,
and Remote Diagnostics. The server can be booted to the service partition, either locally or
remotely, to provide access to the utilities.
For more information on Intel
®
Server Management
and the individual ISM applications, see
the ISM CD.
Security
Intrusion Switch Monitoring
To help prevent unauthorized entry or use of the server, Intel
®
Server Management server
management software monitors the chassis intrusion switch if one is installed. Opening an
access cover will transmit an alarm signal to the server board, where BMC firmware and
server management software process the signal. The system can be configured through
ISM
to respond to an intrusion a number of ways, including powering down or locking the
keyboard.
Software Locks
The BIOS Setup and the System Setup Utility
(SSU) provide a number of security features
to prevent unauthorized or accidental access to the system. Once the security measures
are enabled, you can access the system only after you enter the correct password(s). For
example:
•
Enable the keyboard lockout timer so that the server requires a password to reactivate
the keyboard and mouse after a specified time out period 1 to 120 minutes.
•
Set and enable a supervisor password.
•
Set and enable a user password.
•
Set secure mode to prevent keyboard or mouse input and to prevent use of the front
panel reset and power switches.
•
Activate a hot key combination to enter secure mode quickly.
•
Disable writing to the diskette drive when secure mode is set.
•
Disable access to the boot sector of the operating system hard disk drive.