MAXDATA PLATINUM - Loading a Saved Configuration

45
MAXDATA PLATINUM Server Board
Loading a Saved Configuration
To load a previously saved system configuration from a file using the System Setup Utility:
1.
From the SSU
Main window, choose Config Save/Restore. (Configuration Save/Restore
is available only in Expert mode.)
2.
Click Restore from File and specify a filename and location.

NOTE
You can load only a configuration that had been previously saved with the SSU.
To restore the system configuration from a file using the Server Configuration Utility:
1.
Boot from the Resource CD into the Server Configuration Wizard.
2.
Select the Server Configuration Wizard > Load from Diskette. Click continue.

NOTE
You can load only a con guration that had been previously saved with the Server Con gura-
tion Wizard.
The utility reads the platform type, BIOS revision, and  rmware revision from the  le and
compares that information with the same information retrieved from the server. If the two
do not match, an error message is displayed and the load operation aborts. If they do match,
the utility saves the con guration data to the server. You will need to reboot your server for
the changes to take effect.