Maxell MP-JU4001 - Page 109

109
QM00991-1
Maintenance
Cleaning and replacing the air lter (continued)
►Before taking care of the air lter, make sure the power cord is
not plugged in, then allow the projector to cool su󰀩ciently. Taking care of the air
lter in a high temperature state of the projector could cause an electric shock, a
burn or malfunction to the projector.
►Use only the air lter of the specied type. Do not use the projector without the
air lter or the lter cover. It could result in a re or malfunction to the projector.
►Clean the air lter periodically. If the air lter becomes clogged by dust or the
like, internal temperatures rise and could cause a re, a burn or malfunction to
the projector.
WARNING
• Reset the lter time only when you have cleaned or replaced the air
lter, for a suitable indication about the air lter.
• When the projector displays the “CHECK THE AIR FLOW” message, turn o󰀨
the projector to prevent the internal heat level rising.
NOTE
9.
Turn the projector on and reset the lter time using the FILTER TIME item
in the EASY MENU.
(1) Press the MENU button to display a menu.
(2) Point at the FILTER TIME using the ▲/▼ buttons, then press the ► button.
A dialog will appear.
(3) Press the ► button to select “OK” on the dialog. It performs resetting the
lter time.