Maxell MP-JU4001 - Page 9

9
QM00991-1
Introduction
Warnings, Cautions, and Notices (continued)
► Do not place the projector in a place where it can be hot nor block the
projector's ventilation openings.
• The projector may shut down automatically, or may malfunction due to high
internal temperature if it is placed in a place where it can be hot or ventilation
does not operate normally.
• The heat could have adverse inuence on the cabinet of the projector and
other parts.
• Place the projector in a cool place with su󰀩cient ventilation.
• Do not place the projector in direct sunlight or near hot objects such as heaters.
• Do not place the projector where the air from an air conditioner or similar unit
will blow on it directly.
• Do not put the projector or the accessories in a microwave oven.
• Do not stop up, block nor cover the projector's vent holes.
• Do not place anything around the projector that could be sucked in or stuck to
the projector's intake vents.
• Do not place the projector on carpet, cushions or bedding.
► Avoid placing the projector in smoky, humid, or dusty place, or in a place
where it can be a󰀨ected by soil salinity.
• Accumulations of dust inside the projector result in re or malfunction.
• Do not place the projector near a smoky, humid or dusty place (ex. a smoking
space, a kitchen, a beach, etc.).
• Do not place the projector near humidiers. Especially for an ultrasonic
humidier, chlorine and minerals contained in tap water are atomized and could
be deposited in the projector causing image degradation or other problems.
• Do not place the projector outdoors.
CAUTION
(continued on next page)