Comet Executive Gas Repair
7-1
Chapter 7
REPAIR
Although designed for long service life, some individual consumable parts of the Comet Executive™
Gas eventually wear during normal use and must be cleaned, adjusted, or replaced. This chapter includes
the following sections:
7.1 Safety Considerations 7.5 Ironing Section
7.2 Parts Availability 7.6 Burner System
7.3 Feed Section 7.7 Return Section
7.4 Compression Roll
As a general rule:
• Replace ribbons when they are worn or broken, when tension can no longer be adjusted, or
when atwork does not feed smoothly into the ironing section.
• Replace roll covers when they are worn smooth, when the ribbons slip in place, or when the
general nish of the atwork is unsatisfactory after other causes have been ruled out.
• Clean the ironing cylinder when deposits or debris aect the nish of processed atwork.
• Follow the Preventive Maintenance Schedule beginning on page 4-1.
WARNING
Do not try to repair or correct any condition without reading and
understanding this Repair Chapter.
Only qualied personnel should troubleshoot and repair the machine.
WARNING
Always ensure the unit is completely cooled down and the power is
shut OFF at the main disconnect switch before servicing the unit.
To Next Page
Loading...