11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
66
NOTE: Platform seats must be removed from lift arms to adjust position of underride
assembly. Seats must be reinstalled after adjusting position.
5. Unbolt each of the 2 platform
seats (FIG. 66-1B).
ADJUSTING UNDERRIDE ASSEMBLY
4. Lower platform to the ground. Then, unfold
platform and fl ipover (FIG. 66-1A).
LH SEAT
RH SEAT
UNBOLTING PLATFORM SEAT
(LH SEAT SHOWN)
FIG. 66-1B
PLATFORM
SEAT
LOCK NUT
(2 PLACES)
FLAT WASHER
(2 PLACES)
CAP SCREWS
(2 PLACES)
LIFTGATE WITH PLATFORM ON THE GROUND
(STANDARD FMVSS UNDERRIDE SHOWN)
FIG. 66-1A
STEP 15 - ADJUST UNDERRIDE - Continued
NOTE: If your underride is not in the correct position for bed height of vehicle, per-
form the following procedure.
To Next Page
Loading...
