11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
67
UNBOLTING/BOLTING
UNDERRIDE BRACKET
(LH BRACKET SHOWN)
FIG. 67-1B
STEP 15 - ADJUST UNDERRIDE - Continued
ADJUSTING UNDERRIDE
(STANDARD FMVSS
UNDERRIDE SHOWN)
FIG. 67-1A
UNDERRIDE
BRACKET
LOCK NUT
FLAT WASHER
(2 PLACES)
CAP SCREW
LH LIFTING
ARM
NOTE: At the lowest bed heights, underride may have too little ground clearance
for a jack. If necessary, raise the platform up to 6” to get a jack in position to
support the underride.
UNDERRIDE
JACK
(UNDERRIDE
SUPPORT)
6. Adjust position of the underride assembly as follows. Support
underride with fl oor jack (FIG. 67-1A). Next, unbolt LH un-
derride bracket (FIG. 67-1B) and RH underride bracket from
lifting arms.
8. Lower and remove fl oor jack (FIG. 67-1A).
7. Swing the underride to the hole setting
observed in FIGS. 64-1B, 64-2B or 65-1B.
Bolt the underride brackets in the new posi-
tion (FIG. 67-1B). Torque the 1/2”-13 cap
screws to 85 lb-ft.
To Next Page
Loading...
