11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
73
WELDING FLATS TO SUPPORT
BRACKETS (RH SIDE SHOWN)
FIG. 73-1
12. When the underride is in correct
position, weld the fl ats on the
tube to the RH and LH underride
support brackets as shown in
FIG. 73-1.
UNDERRIDE
TUBE
FLAT
RH UNDERRIDE
SUPPORT BRACKET
1/4”
2 PLACES
1/4”
2 PLACES
DATE OF MFR DECAL
(INBOARD OF BRACKET)
STEP 15 - ADJUST UNDERRIDE - Continued
CAUTION
Prevent the date of manufacture decal from being damaged. Cover decal
when welding underride support brackets.
CAUTION
To protect the original paint system, a 3” wide area of paint must be re-
moved from all sides of the weld area before welding.
CAUTION
When using an electric welder, connect the welder to one of the parts being
welded, as close to the weld as possible. Failure to comply could result in
damage to cylinders and electrical parts.
To Next Page
Loading...
