128
Controls in detail
Seats
When entering the vehicle with the
easy-entry/exit feature activated, the
steering wheel or, depending on your se-
lection, the steering wheel and driver’s
seat will return to their last set position
or a factory-set maximum forward posi-
tion when you
close the driver’s door with the igni-
tion switched on
insert the SmartKey into the starter
switch or press the KEYLESS-GO**
start/stop button ( page 55) once
with the driver’s door closed.
i
If the current position for the steer-
ing wheel is in the uppermost tilt po-
sition, the steering wheel will no
longer be able to move upward when
the easy-entry/exit feature is activat-
ed.
If the current seat position falls into a
factory-set position range and the
system recognizes the current seat
position to be rearward enough for
easy entry and exit, the driver’s seat
will not move to the rear when the
easy-entry/exit feature is activated.
i
For safety reasons, the driver’s seat
will not return to its last set position
with the easy-entry/exit feature acti-
vated if the system recognizes the last
set position as an extreme forward
position. Instead, the driver’s seat will
remain at or move to a factory-set
maximum forward position. To again
fully return the driver’s seat to your
last set position or to memory posi-
tion, adjust the seat to the desired
position or press and hold the respec-
tive memory position button
(
page 141).
To Next Page
Loading...
