432
Practical hints
Replacing bulbs
1 Housing cover for fog lamps, high
beam flasher bulb, parking and
standing lamp
2 Bulb socket for turn signal lamp
3 Bulb socket for side marker
4 Low beam and high beam (Bi-Xenon)
housing cover
5 Bulb socket for high beam flasher
bulb
6 Parking and standing lamp
7 Bulb socket for fog lamps
Low beam and high beam bulbs
High beam flasher bulbs or fog lamps
Switch off the lights.
Open the hood ( page 355).
Twist housing cover 1 counterclock-
wise and pull out.
Twist bulb socket 5 (high beam
flasher bulb) or 7 (fog lamps) coun-
terclockwise and pull out.
Push bulb into socket, turn counter-
clockwise and remove.
Insert new bulb in socket, push in and
twist clockwise.
Reinsert bulb socket 5 (high beam
flasher bulb) or 7 (fog lamps) in
lamp and twist clockwise.
Align housing cover 1 and twist
clockwise.
Replacing bulbs for front lamps
Warning! G
Do not remove the cover for the Bi-Xenon
headlamp. Because of high voltage in Xe-
non lamps, it is dangerous to replace the
bulb or repair the lamp and its compo-
nents. We recommend that you have such
work done by a qualified technician.
To Next Page
Loading...
