219
Controls in detail
Power windows
Switch on ignition ( page 54).
Opening the windows
Press switch 1 to 4 at the
symbol k to resistance point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
Press switch 1 to 4 at the
symbol j to resistance point.
The corresponding window will move
upwards until you release the switch.
Fully opening the windows
(Express-open)
Press switch 1 to 4 at the
symbol k past the resistance point
and release.
The corresponding window opens
completely.
Fully closing the windows
(Express-close)
Press switch 1 to 4 at the
symbol j past the point of resis-
tance and release.
The corresponding window closes
completely.
i
Operating the windows from the rear
is not possible if you activate the
override switch ( page 94).
i
With the SmartKey in starter switch
position 0 or removed from the start-
er switch, the power windows can be
operated
until you open the driver’s or pas-
senger door
for at least five minutes.
i
Vehicles with rear side window cur-
tains* (
page 281):
When opening a side window with
the rear side window curtain not
completely opened, the curtain will
open first.
Warning! G
If you press and hold the switch up when
closing the window, and upward move-
ment of the window is blocked by some
obstruction including but not limited to
arms, hands, fingers, etc., the automatic
reversal will not operate.
Warning! G
Driver's door only:
If within five seconds you again press the
switch past the resistance point and re-
lease, the automatic reversal will not func-
tion.
To Next Page
Loading...
