440
Practical hints
Flat tire
1 - 5 Wheel bolts
Tighten the five wheel bolts evenly,
following the diagonal sequence il-
lustrated (1 to 5), until all bolts are
tight. Observe a tightening torque of
110 lb-ft (150 Nm).
Before storing the jack in the trunk, it
should be fully collapsed, with handle
folded in.
Place the wheel bolt wrench, chock,
alignment bolt and jack back in the
trunk.
Replacing jack support tube cover
Slide tongue of cover under the up-
per edge of the tube opening.
Applying even pressure, press cover
until it snaps into place. Be careful
not to damage the locking tabs or
clamp the plastic retaining strap.
Warning! G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque
of 110 lb-ft (150 Nm).
!
You can also secure the damaged
wheel down into the spare wheel
well in the trunk.
Do not activate the tire inflation pres-
sure monitor (
page 365) until the
depressurized tire is no longer in the
vehicle.
To Next Page
Loading...
