72
Getting started
Driving
Intermittent wiping
Set the wiper switch to position I.
Single wipe
Press switch briefly in direction of
arrow 1.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
Push switch in direction of arrow 1
past the resistance point.
The windshield wiper operates with
washer fluid.
For information on filling up the washer
reservoir, see "Windshield washer and
headlamp cleaning system"
(
page 362).
!
Do not leave windshield wipers in in-
termittent setting when vehicle is
taken to an automatic car wash or
during windshield cleaning. Wipers
will operate in the presence of water
sprayed on the windshield, and wip-
ers may be damaged as a result.
The switch should not be left in inter-
mittent setting as the wipers will
wipe the windshield once every time
the engine is started. Dust that accu-
mulates on the windshield might
scratch the glass and/or damage the
wiper blades when wiping occurs on
a dry windshield.
i
Intermittent wiping is interrupted
when the vehicle is at a standstill and
a front door is opened.
!
If anything blocks the windshield
wipers (leaves, snow, etc.), switch
them off immediately.
For safety reasons,
turn off the engine by turning
the SmartKey to position 0 and
withdraw SmartKey from
starter switch.
or
turn off the engine by pressing
the KEYLESS-GO** start/stop
button ( page 55) and open
the driver’s door (with the
driver’s door open, starter
switch is in position 0, same as
with SmartKey removed from
starter switch)
before attempting to remove any
blockage.
Remove blockage.
Turn the windshield wipers on
again.
If windshield wipers fail to function
at all in switch position I:
Set the combination switch to the
next highest wiper speed.
Have the windshield wipers
checked at the nearest authorized
Maybach Studio.
To Next Page
Loading...
