MAINTENANCE
Electrical Connection W_'_VING: To reduce the risk ofaccideninl
Uppingof the range, it must be secured by"a
Appliances which require electrical power are properly installed anti-tip device. To check if the
equipped with a three-prong grounding plug
devine is installed properly; use a flashlight and
which must be plugged directly into a properly look underneath the range to see that one of the
grounded three-hole I20 volt electrical outlet, rear leveling legs is engaged in the bracket slot,
If an ungrounded, two-hole or other type The anti-tip device secures the rear leveling leg
electrical outlet is encountered, it is the ro the floor, if properly engaged.
personal responsibility of the appliance
owner to have receptacle replaced with a
properly grounded three hole electrical Light Replacement
outlet. The three-prong grounding plug is Before replacing the light bulb, disconnect the
provided for protection against shock hazards, power to the range. Be sure the bulb is cool
Do not cut or remove the third grounding Do not touch a hot bulb with a damp cloth as the
prong from the power cord plug. bulb may break.
To Replace Panel Light
Grasp the top trim of the backpanel with your
)_ thumbs under the front edge and pull outward
while lifting to release the trim from the catches
_ at each end. Remove the bulb and replaee it with
,. _-4 _3 an 18 watt fluorescent tube. Snap the top trim
back into place and restore the power. Reset the
, eloek to the current time-of-day.
/
Always disconnect power to appliance before servicing. _ _'L.... _ _
Leveling Legs
Some floors are not level. For proper baking,
your range must be level. The leveling legs are
located on each comer of the base of the range.
Level the range by turning the legs.
/ N
PAGE21
To Next Page
Loading...
