25
The Prewash Sequence
Menu Item Description Default Limits
Temperature The water temperature. 104°F
(40°C)
33.8–113°F
(1–45°C)
Inlet The suggested Inlet Valves are related to the temperature and the Soap
Box to be used.
If you insert Inlet Valves other than those suggested, problems
can occur at the water fill process.
11–15 11–18
Level The suggested water level depends on the Machine Type. Normal
Low
See Table A-3
RPM The suggested RPM depends on the Machine Type. – See Table A-5
Detergents Menu...
Supply 1, ..., 8
Time selection for external liquid soap supplies. You can program
up to 4 supplies at the same time; attempting to program more than 4
supplies will generate an error message. Only 4 non-zero supplies per
step are accepted.(Liquid soap supplies must be switched on at the
Configuration Menu.)
0 sec 0–99 sec
On Time The wash action, motor On Time.
Gentle wash action: 3 seconds
(The suggested default values can be adjusted in the Initialization Menu)
12 sec 1–99 sec
Off Time The wash action, motor Off Time.
Gentle wash action: 12 seconds
(The suggested default values can be adjusted in the Initialization Menu)
3 sec 1–99 sec
Time The Prewash Sequence Time.
(for 0 minutes the Prewash sequence will be skipped (programmable in
steps of 0.5 minutes)
4 min 0–99.5 min
Signal When a signal is programmed, a pause will be introduced at the end
of the Wash Step. This allows the operator to add soap for the next step.
A buzzer signal warns the operator that the cycle has been interrupted.
No No/Yes
Prewash Wash Cool Down Rinse Final Rinse Soak Spray No Wash
To Next Page
