Why does my Maytronics Dolphin Liberty stop before finishing the cycle?
Your Maytronics Swimming Pool Vacuum might stop before completing its cleaning cycle due to several reasons. First, check if the impeller or the drive system is blocked. Another reason may be that the battery is empty, so try charging the robot.
What to do if the 'No connection' LEDs are lit when charging my Maytronics Swimming Pool Vacuum?
If the 'No connection' LEDs are lit when charging your Maytronics Swimming Pool Vacuum, verify that the charging cable is properly connected and that the connectors are dry. If the problem persists, wait 10 seconds and try again.
What to do if my Maytronics Swimming Pool Vacuum is not sinking?
If your Maytronics Swimming Pool Vacuum is not sinking, and if you are using Wonder brushes or combined brushes, make sure they are soaked in water.
General| Navigation | Smart Navigation |
|---|---|
| Remote Control | No |
| Wi-Fi Connectivity | No |
| Warranty | 2 years |
| Type | Robotic |
| Pool Type | In-ground |
| Filtration | Fine filtration |
Details robot's technical specifications, including motor protection and pool water parameters.
Lists technical specifications for the digital switch-mode charger.
Provides detailed specifications for the robot's lithium-ion battery.
Guides on caddy assembly, charger positioning, and handle angle adjustment.
Explains the function and indicators of the interactive float.
Step-by-step guide for cleaning the robot's filter cartridges.
Instructions for disassembling and cleaning the robot's impeller.
Guidelines for proper storage of the robot to maintain its condition.
Overview and explanation of the remote control unit's buttons and indicators.
Instructions for operating the robot using manual direction control.
Explains how to configure various automatic cleaning modes and parameters.
To Next Page