2
CLASSIC 15+ Robotic Pool Cleaner | User Instructions
1. INTRODUCTION
Thank you for purchasing a Maytronics robotic pool cleaner.
We are sure that your Maytronics robotic pool cleaner will provide you with reliable, convenient and
cost effective pool cleaning. Its reliable filtration in all pool conditions and all-surface climbing brush
enhance maximum pool hygiene.
The robotic pool cleaners by Maytronics deliver advanced cleaning technology, long lasting performance
and easy maintenance.
2. SPECIFICATIONS
Robot
Motor protection: IP68, up to 5 m
Minimum depth: 0.4 m (1.33 ft)
Maximum depth: 5 m (16.4 ft)
This product complies with EU Directives 2014/35/EU, 2014/53/EU, 2014/30/EU, RoHS and REACH.
For full information, please contact us at www.maytronics.com/contact-us-en
and ask for the EU Declaration of Conformity.
3. WARNINGS AND CAUTIONS
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Please adhere strictly to the following WARNINGS:
Digital switch-mode power supply
IP54
Input: 100 VAC to 240 VAC, 50-60Hertz, 180 Watt
Output: <30 VDC
Bluetooth® max output < 5.7mW
Wi-Fi® max output < 76mW - Frequency 2.4MHz
____________________________________________________________________________________________________________________________________________________________________________________________________________
Position the Caddy and power supply at least 3.5 m (12 ft) from pool’s edge – during operation.
____________________________________________________________________________________________________________________________________________________________________________________________________________
Take the robotic pool cleaner out of the pool before allowing people to enter the pool.
____________________________________________________________________________________________________________________________________________________________________________________________________________
When examining the robotic pool cleaner, disconnect the main power supply.
____________________________________________________________________________________________________________________________________________________________________________________________________________
Ensure that children do not attempt to access the robotic pool cleaner while it is operating.
Keep the robotic pool cleaner out of the reach of children or persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction. Cleaning and maintenance shall not be done by children.
____________________________________________________________________________________________________________________________________________________________________________________________________________
Only an original power cord must be used, at all times. If damaged, it must be replaced by a robotic
pool cleaner certified technician to avoid hazards.
____________________________________________________________________________________________________________________________________________________________________________________________________________
To reduce the risk of electric shock replace damaged cord immedietely.
____________________________________________________________________________________________________________________________________________________________________________________________________________
Do not use an extension cord to connect unit to the outlet; provide a properly located outlet.
____________________________________________________________________________________________________________________________________________________________________________________________________________
The power supply must be supplied through a residual current device (RCD) having a rated residual
operating current not exceeding 30mA.
For USA/Canada installations:
The power supply must be connected only to a supply circuit that is protected by a ground fault circuit
interrupter (GFCI). This GFCI should be tested on a routine basis.
To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power
should be restored. If the GFCI fails to operate in this manner, the GFCI is defective.
If the GFCI interrupts power to the power supply without the test button being pushed, a ground
current may be flowing, indicating the possibility of an electric shock. Do not use the power supply.
Disconnect the power supply and contact the manufacturer for assistance.
____________________________________________________________________________________________________________________________________________________________________________________________________________
To Next Page