Refer to Radar Sensors on page
5-112.
The road is on a steep slope.
The road is extremely wide.
You make a lane change 2 lanes or
more.
The BSM may operate when turning
at intersections in urban areas or
with stationary objects on the road
or the roadside (such as guardrails,
sidewalls, and parked vehicles).
If a Mazda genuine trailer hitch is
used, the BSM is automatically
turned off when the trailer's
electrical connector is connected.
When pulling a trailer other than
with a Mazda genuine trailer hitch,
or while an accessory such as a
bicycle carrier is installed to the rear
of the vehicle, turn off the BSM.
Otherwise, the radar’s radio waves
will be blocked causing the BSM to
not operate normally.
The brightness of the BSM warning
lights is linked to the panel light
control.
Refer to Dashboard Illumination on
page 5-30.
Turning
off
the warning sound
There are 2 ways to turn off the
warning sound while the BSM is
operating.
Turn
off
the warning sound using
Mazda Connect.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
Turn
off
the warning sound using the
i-ACTIVSENSE mute switch.
Refer to How to Use the
i-ACTIVSENSE mute switch on page
5-107.
Turning off the BSM
The BSM can be turned off using the
Mazda Connect.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
Driving
Blind Spot Monitoring (BSM)
5-129
Mazda3_8LX5-EA23E_Edition2_new 2023-4-17 20:22:43
To Next Page
Loading...
