Mazda 3 2004 - How to Use the ISOFIX Lower Anchor (Mexico);LATCH Lower Anchor (Except Mexico)

Make sure the child-restraint system is
properly secured.
An unsecured child-restraint system is
dangerous. In a sudden stop or a
collision it could move causing serious
injury or death to the child or other
occupants. Follow the child-restraint
system manufacturer's instructions on
belt routing to secure the seat just as
you would with a child in it so that
nobody is tempted to put a child in an
improperly secured seat later on.
When not in use, remove it from the
vehicle or fasten it with a seat belt, or
attach it to BOTH ISOFIX/LATCH
*1
lower anchors for ISOFIX/LATCH
*1
child-restraint systems.
Make sure there are no seat belts or
foreign objects near or around the
ISOFIX/LATCH
*1
child-restraint
system.
Not following the child-restraint system
manufacturer's instructions when
installing the child-restraint system is
dangerous. If seat belts or a foreign
object prevent the child-restraint
system from being securely attached to
the ISOFIX/LATCH
*1
lower anchors
and the child-restraint system is
installed improperly, the child-restraint
system could move in a sudden stop or
collision causing serious injury or death
to the child or other occupants. When
installing the child-restraint system,
make sure there are no seat belts or
foreign objects near or around the
ISOFIX/LATCH
*1
lower anchors.
Always follow the child-restraint
system manufacturer's instructions.
*
1 ISOFIX (Mexico)/LATCH (Except
Mexico)
How to Use the ISOFIX
Lower Anchor (Mexico)/
LATCH Lower Anchor
(Except Mexico)
Installation on rear outboard seat
1. First, adjust the front seat to allow
clearance between the
child-restraint system and the front
seat.
Refer to How to Use the Front Seats
on page 3-34.
2. Make sure the seatback is securely
latched by pushing it back until it is
fully locked.
3. Remove the cover of the
child-restraint system's ISOFIX/
LATCH
*1
lower anchors to verify the
locations of the ISOFIX/LATCH
*1
lower anchors.
1. ISOFIX/LATCH lower anchor
*1
NOTE

The ISOFIX/LATCH
*1
lower
anchors marking on the cover
indicates the position of the
ISOFIX/LATCH
*1
lower anchors
for the attachment of a
child-restraint system.
Equipment to Protect Occupants/Pedestrians
Child-restraint Systems
3-67
Mazda3_8LX5-EA23E_Edition2_new 2023-4-17 20:22:43