EasyManua.ls Logo

Mazda 3 2004 - Child-Restraint System Suitability for Various Seat Positions Table

Mazda 3 2004
619 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Child-Restraint System Suitability for Various Seat
Positions Table
(Mexico)
Provided information in the table shows your child-restraint system suitability for
various seating position. For installation suitability of other manufacturer
child-restraint system, carefully consult the manufacturer's instructions which
accompany the child-restraint system.
When installing a child-restraint system, the following points must be observed:
Always remove the head restraint before installing a child-restraint system.
However, when installing a backless booster seat, always install the vehicle head
restraint to the seat where the backless booster seat is installed. In addition,
always use a tether strap and attach it securely. Refer to How to Use the Head
Restraints on page 3-44.
When installing a child-restraint system to the front passenger seat, adjust the seat
slide position as far back as possible.
Refer to How to Use the Front Seats on page 3-34.
When it is difficult to install a child-restraint system to the front passenger seat, or
the seat belt cannot be secured to the child-restraint system, perform the
following operations to adjust the seat holding the child-restraint system so that
the seat belt can be secured completely to it.
Move the seat forward or back.
Move the seatback forward or back.
When installing a child-restraint system to the rear seat, adjust the front seat
position so that the front seat does not contact the child-restraint system.
Refer to How to Use the Front Seats on page 3-34.
When installing a child-restraint system equipped with a tether, remove the head
restraint.
Refer to How to Use the Head Restraints on page 3-44.
An i-Size child-restraint system refers to a child-restraint system which has
acquired i-Size category certification for the UNR 129 regulation.
When installing a child-restraint system to the rear seat, refer to the child-restraint
system manufacturer's instructions and the Using the ISOFIX Lower Anchor
(Mexico)/LATCH Lower Anchor (Except Mexico) on page 3-66.
Seating position Passenger Rear (Left) Rear (Center) Rear (Right)
Seating position
suitable for univer-
sal belted (Yes/No)
Yes (UF) Yes (U) Yes (U) Yes (U)
i-Size seating posi-
tion (Yes/No)
No No No No
Equipment to Protect Occupants/Pedestrians
Child-restraint Systems
3-54
Mazda3_8LX5-EA23E_Edition2_new 2023-4-17 20:22:43

Table of Contents

Other manuals for Mazda 3 2004

Related product manuals